K03 Double filet clamp (Gen 3 ONLY)

[See picture of fixing units on Products page] Note:  Comes with Gen 3 fixing units.  Only works with sharpeners delivered after mid-Dec 2017.

Special clamp with reduced sharpening angle for thin and narrow filet knives. The clamp has fine jaws made of spring steel which provide proper clamping. The clamp has a redesigned shape for the clamping jaws and special screws. The minimum sharpening angle is 6.5 degrees per side. It is not recommended for use with knives more than 2.5mm thick to avoid damage to jaws.
Recommended Knife Length for the Clamp: 50 — 200mm (2 - 8 inches)
Minimal Knife Width: 10mm (3/8 inch)
Max Knife Thickness: 2.5mm (1/10 inch)
Range of angles: 6.5°— 32°

Note:  Slotted bar not included

Note 2: If you need to get another screw that goes in the end, near the tip of the jaws, it is an M3-0.5 mm Internal Hex Button-Head Cap Screw

* Also fits the K01 System with Double Clamp Frame.

** Comes with a new, aluminum one-piece fixing unit